In this tutorial, the Bullet penetration model using large deformation explicit finite element simulations of rapid penetration in soil in Abaqus software has been studied. The bullet is modeled as a three-dimensional part, and the soil as an Eulerian model. You can see a figure of the assembled parts below ...
ادامه نوشته »Abaqus Full Lecture of Soil modeling, pile group and piled raft, consolidation, bearing capacity, …more than ten hours simulation
In this full lecture, all aspects of soil modeling and simulation are represented. The lecture contains twenty titles about soil, saturated soil, TBM, earthquake, tunnel, embankment construction, geocell reinforced soil, geosynthetic-reinforced soil retaining wall, earthquake over a concrete tunnel, embankment, and excavation, soil consolidation in interaction with the concrete pile, ...
ادامه نوشته »Simulation Pressure Distribution on Subgrade Soil Underlying Geocell Reinforced Foundation Bed in Abaqus
In this tutorial, the Simulation Pressure Distribution on Subgrade Soil Underlying Geocell Reinforced Foundation Bed in Abaqus has been studied. High contact stresses generated in the foundation soil, owing to increased load, causes distress, instability, and large settlements. Present days, geocell reinforcement is being widely used for the performance improvement ...
ادامه نوشته »Simulation geosynthetic-reinforced soil retaining wall in Abaqus
In this tutorial Simulation geosynthetic-reinforced soil retaining wall in Abaqus has been investigated. The soil is modeled as two dimensional part with elastic ,cap plasticity material with hardening. The geosynthetic is modeled as 2 dimensional wire model with elastic material with beam element.You can see figures about the assembled parts ...
ادامه نوشته »Simulation end bearing capacity of a pile under rapid load in Abaqus
In this tutorial simulation end bearing capacity of a pile under rapid load in Abaqus base in the Sam Helwany book has been investigated. To model pile and soil asymmetric shell parts has been used.In geotechnical engineering, bearing capacity is the capacity of soil to support the loads applied to ...
ادامه نوشته »Simulation Bearing Capacity Failure of a Strip Foundation in Abaqus
In this tutorial Simulation Bearing Capacity Failure of a Strip Foundation in Abaqus base on the Sam Helwany’s book has been studied. Because of the symmetric condition, two dimensional shell part is used for both soil and foundation. You can see a figure of schematic at below Elastic material for ...
ادامه نوشته »Simulation concrete piled raft in interaction with soil in Abaqus
In this tutorial Simulation concrete piled raft in interaction with soil in Abaqus has been done.The piled raft foundation system has recently been widely used for many structures, especially high rise buildings. In this foundation, the piles play an important role in settlement and differential settlement reduction, and thus can ...
ادامه نوشته »Simulation earthquake over a concrete tunnel in interaction with soil in Abaqus
In this tutorial Simulation earthquake over a concrete tunnel in interaction with soil in Abaqus has been investigated. The tunnel industry has considered that tunnels, especially tunnels in rock, are naturally resistant to earthquake action, including faulting, shaking, deflection and ground failure. As the number of case histories of tunnels ...
ادامه نوشته »