تمامی مطالب این سایت محفوظ بوده و هر گونه کپی برداری از مطالب این سایت پیگرد قانونی دارد.
خانه / Abaqus tutorial videos / Abaqus advanced tutorials / Abaqus Full Lecture of Soil modeling, pile group and piled raft, consolidation, bearing capacity, …more than ten hours simulation

Abaqus Full Lecture of Soil modeling, pile group and piled raft, consolidation, bearing capacity, …more than ten hours simulation

In this full lecture, all aspects of soil modeling and simulation are represented. The lecture contains twenty titles about soil, saturated soil, TBM, earthquake, tunnel, embankment construction, geocell reinforced soil, geosynthetic-reinforced soil retaining wall, earthquake over a concrete tunnel, embankment, and excavation, soil consolidation in interaction with the concrete pile, earthquake over gravity dam, infinite element method, Sequential Construction, calculation the total load capacity of the pile group, bearing capacity of the foundation, and other related subjects are investigated. The lecture introduced twenty sections, and in each section, the tutor explained everything from A to Z. Each section contains cae, inp, step-by-step English video, and research papers. The material models like Cap, Clay, Mohr-Coulomb, and Concrete Damaged Plasticity are used. You can check the titles below, and they are the lecture sections

Simulation embankment construction with geocell on the saturated soil in Abaqus

Simulationof  Pressure Distribution on Subgrade Soil Underlying Geocell Reinforced Foundation Bed in Abaqus

Simulation geosynthetic-reinforced soil retaining wall in Abaqus

Simulation concrete piled raft in interaction with soil in Abaqus

Simulation earthquake over a concrete tunnel in interaction with soil in Abaqus

Simulation embankment and excavation on saturated soil in Abaqus

Simulation of soil consolidation in interaction with a concrete pile in Abaqus

Simulation geosynthetic-reinforced soil retaining wall beside a heap of soil in Abaqus

Simulation of embankment construction on a saturated soil floor in Abaqus

Simulation of TBM modeling into the dry mix with saturated soil in Abaqus

Simulation Pile in interaction with soil under vertical load in Abaqus

Simulation Concrete wall in the soil in Abaqus

Simulation of pile penetration into the soil in Abaqus

Simulation earthquake over a gravity dam in interaction with water and soil by using the infinite element method

Simulation sequential embankment construction and earthquake analysis after it in Abaqus

Simulation Sequential Construction of an Embankment on a Clay Layer in Abaqus

Simulation and calculation of the total load capacity of the pile group in Abaqus

Simulation bearing capacity of a three-dimensional square foundation in Abaqus

Simulation end bearing capacity of a pile under rapid loading in Abaqus

Simulation Bearing Capacity Failure of a Strip Foundation in Abaqus

Simulate and calculate the long-term load capacity of a pipe pile in Abaqus

The cost for this lecture contains Twenty separated models step by step more than ten hours duration is Forty-Nine Euros. You can use a PayPal account, a Visa, or a Master card for the payment.

Before payment, send me an email to this address: karampourp@gmail.com

درباره ی Abaqus

همچنین ببینید

Simulation blast resistance behavior of adhesively bonded cross-laminated timber-concrete composite

Introduction to Simulation of Blast Resistance Behavior of Adhesively Bonded Cross-Laminated Timber-Concrete Composite (CLT-CC) Overview ...

دیدگاهتان را بنویسید

نشانی ایمیل شما منتشر نخواهد شد. بخش‌های موردنیاز علامت‌گذاری شده‌اند *

تمامی مطالب این سایت محفوظ بوده و هر گونه کپی برداری از مطالب این سایت پیگرد قانونی دارد.
enemad-logo