بایگانی برچسب: abaqus soil modeling

In this tutorial, the Bullet penetration model using large deformation explicit finite element simulations of rapid penetration in soil in Abaqus software has been studied. The bullet is modeled as a three-dimensional part, and the soil as an Eulerian model. You can see a figure of the assembled parts below ...

In this tutorial, the Seismic analysis of geosynthetic-reinforced soil in Abaqus has been investigated. The soil is modeled as a two-dimensional part. The geosynthetic is modeled as a wire part. You can see a figure of the assembled parts below Geosynthetic-reinforced soil (GRS) structures perform well during strong earthquakes due ...

In this full lecture, all aspects of soil modeling and simulation are represented. The lecture contains twenty titles about soil, saturated soil, TBM, earthquake, tunnel, embankment construction, geocell reinforced soil, geosynthetic-reinforced soil retaining wall, earthquake over a concrete tunnel, embankment, and excavation, soil consolidation in interaction with the concrete pile, ...

In this tutorial Simulation bearing capacity of a three dimensional square foundation in Abaqus base on the Sam Helwany’s book has been investigated. To model soil and foundation a one three dimensional part is used.You can see a figure about it at below The elastic and cap plasticity with cap ...

In this tutorial simulation end bearing capacity of a pile under rapid load in Abaqus base in the Sam Helwany book has been investigated. To model pile  and soil asymmetric shell parts has been used.In geotechnical engineering, bearing capacity is the capacity of soil to support the loads applied to ...