بایگانی برچسب: abaqus low cycle fatigue simulation

Welded steel structures are widely used in engineering applications such as bridges, offshore platforms, pressure vessels, and structural frames, where they are frequently subjected to repeated or cyclic loading rather than monotonic loads. Under such conditions, welded joints often become critical locations for damage initiation due to stress concentration, metallurgical ...

Fatigue and Cyclic Loading in Abaqus Mechanical fatigue is a phenomenon where a material undergoes progressive and localized structural damage when subjected to cyclic or fluctuating stresses, even if these stresses are below the material’s ultimate tensile strength. Over time, this repeated loading and unloading can lead to the initiation ...

In this tutorial, the Simulation of low cyclic fatigue damage based on hysteresis energy on Abaqus has been investigated. The steel plated is modeled as a two-dimensional part. You can see a figure of the assembled part below. It is well known that after a number of repetitive loading cycles, ...

In this tutorial Simulation three dimensional fatigue phenomenon in Abaqus by using Paris law has investigated.  Metal fatigue is the process by which a material is slowly damaged by stresses and strains that are less than those needed to actually break the material apart. For example, a steel wire might be ...

In this tutorial Simulation fatigue phenomenon of the steel plate in Abaqus by using direct cyclic step has been investigated.Two dimensional part for steel and wire part to define initial crack length has been used . Elastic material couple with traction separation law to consider the fracture and crack growth in ...