بایگانی برچسب: beam-column structure and damage investigation in Abaqus

In this tutorial, the Simulation CEL explosion inside the RC UHPC building in Abaqus-Damage investigation has been done The Ulta-High-Performance-Concrete(UPHC) building is modeled as a three-dimensional solid part. The reinforcements are modeled as wire part. The TNT is shpere part inside the Eulerian domain. You can see figures of the ...

In this course, you will learn all aspects of steel structure modeling and simulation in Abaqus. The lecture contains sixteen sections, in each section, the tutor has explained all thing from A to Z. Geomert modeling, material definition and equations, steps, interaction, load, mesh, and results. The dynamic bolt failure, ...

In this tutorial, the Simulation Behavior of Beam-Column Joints Strengthened With UHPFRC under axial load in Abaqus has been investigated. The beam-column joint is modeled as three-dimensional solid part. The UHPFRC parts are modeled as three-dimensional solid as reinforcement. The strips and bars are modeled as three-dimensional wire parts. You ...

In this tutorial, the Simulation concrete beam-column joints under cyclic loading in Abaqus-Damage analysis- has been investigated. The concrete beam-column joint is modeled as a three-dimensional solid part. The strips and bars are modeled as three-dimensional wire parts. You can see figures of the assembled parts below The steel material ...

In this tutorial, the Simulation cyclic loading of the steel beam-column structure and damage investigation in Abaqus has been investigated. The beam is modeled as a three-dimensional shell part and two steel columns are modeled as three-dimensional shell part. You can see a figure of the assembled parts below To ...