تمامی مطالب این سایت محفوظ بوده و هر گونه کپی برداری از مطالب این سایت پیگرد قانونی دارد.
خانه / بایگانی برچسب: Simulation sandstone cutting by using a rigid tool in Abaqus

بایگانی برچسب: Simulation sandstone cutting by using a rigid tool in Abaqus

Simulation water jet penetration into the stone piece in Abaqus by using SPH method

In this tutorial, the Simulation water jet penetration into the stone piece in Abaqus by using SPH method  has been studied. The stone is modeled as a three-dimensional solid part. The water column is modeled as a three-dimensional solid part. You can see a figure of the assembled parts below ...

ادامه نوشته »

Simulation sandstone cutting by using a rigid tool in Abaqus-Damage investigation

In this tutorial, the Simulation sandstone cutting by using a rigid tool in Abaqus-Damage investigation – has been studied. The stone part is modeled as a three-dimensional solid part. The tool is imported to the Abaqus as a deformable part, but in the interaction section, the rigid constraint has been ...

ادامه نوشته »
تمامی مطالب این سایت محفوظ بوده و هر گونه کپی برداری از مطالب این سایت پیگرد قانونی دارد.
enemad-logo